Requirements

The table in this topic details system requirements for the Combined Client for Konica Minolta.

Requirement Description
AutoStore

The following are required if capture with AutoStore is enabled in Device Registration Service.

  • AutoStore version 7.0 SP1 or later / AutoStore version 8.0 or later (ControlSuite)
  • Licensed for Konica Minolta iOption capture component
  • Task configured with the Konica Minolta iOption capture component
Equitrac

The following is required it print management with Equitrac is enabled in Device Registration Service.

  • Equitrac 5.7 or later / Equitrac 6.0 or later (ControlSuite)
  • Configure Konica Minolta CC embedded type
Output Manager

The following is required it print management with Output Manager is enabled in Device Registration Service.

  • Build 4.2 or later / Build 5.0 or later (ControlSuite)
  • OM Device configured with:
    • Embedded client type set to KonicaMinolta
    • Unified client option is selected
  • OM Destination associated with the OM Device with the correct printer family definition.
  • Destination Group with Pending Queue.
  • OM Source Output Setting configured to route to the Pending Queue.
Supported devices
Note: Current firmware is recommended for all devices. For bizhub devices with model numbers ending in 7, 8, 8e, and 9 and for bizhub 4052, 4752, C3351, C3851, and C3851FS devices, Control Suite requires GC1-X8 or GC3-X4 firmware, or newer mass ROM firmware.
Hardware requirements
  • Device must have hard drive
Software requirements
  • OpenAPI ver 2.0 or later
  • Web browser iOption kit is installed (LK101)